NoMark

SiliCLEAN Anti-Tracking Films

'No-Mark' SiliCLEAN Anti-Tracking films are used to prevent ink marking and tracking from press transfer cylinders. They effectively replace loose net type materials, last longer, and are much easier to install.

Two SiliCLEAN Surface Choices: Silliclean is available in two surface types; Standard and Diamond. The Standard has a typical press life of six months. Our Diamond surface usually exceeds that by a factor of 4x.

Three Choices of Backing:

Film Only (Type SFO). Build-up: 5.5 mil

No backing. Application determined by the installer. Normally accomplished with tapes, spray adhesive, or with clamps on some press models.
Film + Repositionable Adhesive (Type SRA) Build-up: 8.0 mil

Special repositionable adhesive allows very fast and easy installation on transfer cylinders and Super Blue® or Heidelberg net jackets. Simply pull-up and reposition if it skews during install. Zero adhesive clean-up during change-over provides the added bonus of more productive press time. Our most popular SiliCLEAN!
Film + VELCRO Loop (Type SWV). Build-up: 8.5 mil

A 'sandwich' assembly with a backing of proprietary VELCRO® loop. Type SWV is semi-rigid, enabling it to form a smooth drum when used in conjunction with 'No-Mark' full cylinder anti-tracking system.

Check out what 'No-Mark' SiliClean means to your bottom line

Long On-Press Life
4 Fewer Changeovers
No Lint Picking on Wipe Down
No Messy Adhesives Required With Types SRA & SWV
Lasts 2-3 times longer than other materials!
Economical for ALL presses large or small